150W Vpark TC150 VT/VW Box MOD
coming soon to Smoketokz located and state line and 103rd Street kansas city Missouri. Collection of mods best Christmas gift ever for you smoking loved ones.
150W Vpark TC150 VT/VW Box MOD,it has 150W VW output and support TEMP from 95C-315C/ 200F-600F. With the best solution for temperature control, this device is applying its best technique of TC control, with its outstanding performance from 1W up to 150W offers the best experience for all vapors!
Battery size: 22*60*91mm
Wattage output: 1-150W
Temperature range: 200~600 F or 95~315℃
Maximum output current: 20-35A
Resistance range: 0.1 – 1.0 ohm(Ni200 coil) & 0.16 – 2.0ohm(in wattage setting)
Simple packing. Customary Packing from the factory, the packing is subject to change without notice.
- Aluminum alloy body
- 4 Modes in One Wheel: TC/Wattage/On/Off
- Under voltage protection
- Low resistance protection
- Reverse battery protection
- Output short circuit protection
- High temperature protection
Battery Installation: Open the package, take out Vpark Box TC150, click ‘Clamshell battery cover buckle’ to open the battery cover, and put the battery into compartment in the right position and negative directions.
Active on & off Switch: In shutdown mode, turn mode switch wheel to ‘ON’, ‘W’or ‘F’ any mode of these, begin starting up. 3 seconds after turning mode switch wheel to ‘OFF’, begin shutdown mode, and screen is shut, entering to minimum power consumption status.
Automatic Screen Off: Without any operation after a minute, the screen will automatically shut down, press any key can wake up screen, entering standby interface.
Wattage Adjustment: Turn ‘Mode Switch Wheel’ to ‘W’ and gets into Wattage Adjustment Mode. The word ‘watt’ on screen can be chosen, and you can use Up&Down dial hold down left or right to adjust wattage.
Temperature Adjustment: Turn ‘Mode Switch Wheel’ to ‘F’ and gets into temperature adjustment mode. The word ‘temp’ on screen can be chosen, and you can hold down Up&Down dial left or right to adjust temperature.
Over-Temperature Protection: When the LCD reads ‘TOO HOT’ means that the sensor on RY102 board detected temperature is too high, will automatically power down to 25W output. When it tests the board temperature below the alert value, can return to normal output.
- It can work with 510 threaded clearomizers/tanks.
- No cartomizer/tank comes with.
- It doesn’t come with 18650 lithium battery, you shall buy separately.
Leave a Reply